KPV dosage chart
10 mg Vial
KPV (Lys-Pro-Val) is a bioactive peptide fragment known for its anti-inflammatory, antimicrobial, and tissue-healing properties. It may support gut health, skin health, and overall recovery. Spartan Peptides protocol: mix 10mg KPV with 1mL BAC water.
- Mixing guide
- Mix 10MG KPV with 1mL BAC water.
- Concentration
- 10 mg/mL (1 unit = 0.1mg)
- Recommended dosage
- 250mcg – 1mg daily
- Injection frequency
- Daily — 1–2 times daily — 5 days on, 2 days off (dose Mon–Fri, rest Sat–Sun).
- Syringe
- Use an insulin syringe (U-100) for accurate dosing. 1 unit = 0.01 mL.
- Storage
- Store reconstituted vial refrigerated at 2–8 °C, protected from light. Do not freeze.
- Dosing schedule
- 5 days on / 2 days off: dose Monday through Friday, then take Saturday and Sunday off. That is 5 dosing days per week.
KPV dosing guide (10mg / 1mL BAC water)
| Units (insulin syringe) | Total dose (mcg) |
|---|---|
| 2.5 units | 250mcg |
| 5 units | 500mcg |
| 7.5 units | 750mcg |
| 10 units | 1mg |
Reconstitution steps
- 1Draw 1mL of bacteriostatic water into a sterile syringe.
- 2Inject the water slowly down the inside wall of the 10MG KPV vial.
- 3Swirl gently until fully dissolved — do not shake.
- 4Use a U-100 insulin syringe for accurate dosing.
- 5Store reconstituted solution refrigerated at 2–8 °C, protected from light.
Dosing Cycle & Timing
This protocol runs on a 5 days on / 2 days off cycle.
- Cycle: 5 days on, 2 days off — dose Monday through Friday and rest on the weekend.
- 5 dosing days per week; the 2 off days help limit receptor desensitisation and give injection sites time to recover.
- Keep the dose time consistent on dosing days.
- If a weekday dose is missed, take it the same day if possible — do not dose on an off day to catch up.
- Weekly totals in the supplies and shopping lists are calculated on 5 dosing days, not 7.
Spartan Peptides Official Protocol
Example: 5 units = 500mcg KPV (0.5mg). Adjust based on individual response and goals. Consistent daily use is commonly researched for best results. Inject subcutaneously, run 5 days on and 2 days off.
- Mixing guide: mix 10MG KPV with 1mL BAC water.
- Concentration after mixing: 10 mg/mL (1 unit = 0.1mg).
- Recommended dosage: 250mcg – 1mg daily.
- Injection frequency: Daily — 1–2 times daily on a 5 days on / 2 days off cycle.
- Use an insulin syringe (U-100) for accurate dosing.
Reported Research Focus
Research purposes only. Premium quality. Built on legacy. Backed by science.
- Supports gut health*
- Supports skin health*
- Reduces inflammation*
- Supports recovery*
Important Notes
Practical considerations for consistency and safety.
- Use new sterile insulin syringes for each administration; dispose in a sharps container immediately after use.
- Rotate injection sites systematically (abdomen, thighs, upper arms) at least 1–2 inches apart to reduce local irritation and prevent lipohypertrophy.
- Inject slowly; wait a few seconds before withdrawing the needle to prevent solution backflow.
- Document daily dose, injection site, and any observations to maintain consistency and track tolerability.
- If injection‑site reactions (redness, mild swelling) occur, apply a cool compress and monitor; persistent reactions warrant protocol review.
How This Works
KPV is the C‑terminal tripeptide sequence (residues 11–13) of α‑melanocyte‑stimulating hormone (α‑MSH), retaining potent anti‑inflammatory activity without the hormone’s melanotropic effects. Preclinical studies demonstrate KPV reduces pro‑inflammatory cytokines (TNF‑α, IL‑6, IL‑1β) and modulates immune cell activity in models of inflammatory bowel disease, colitis, and systemic inflammation. The peptide’s mechanism involves inhibition of nuclear factor kappa B (NF‑κB) signaling and modulation of inflammatory mediator release. Subcutaneous administration provides systemic delivery with rapid absorption and sustained anti‑inflammatory effects observed in daily dosing protocols.
Potential Benefits & Side Effects
Observations from preclinical and early‑stage research.
- Anti‑inflammatory activity: Reduces pro‑inflammatory cytokines and modulates immune responses in models of inflammatory bowel disease and systemic inflammation.
- Oral and subcutaneous efficacy: Multiple routes of administration show activity, with subcutaneous injection favored for systemic delivery and consistent bioavailability.
- Wound healing support: Preclinical data suggest KPV may support tissue repair and wound healing processes through inflammatory modulation.
- Generally well tolerated: Occasional mild injection‑site reactions (redness, slight swelling) may occur; systemic side effects are rarely reported in research protocols.
- No melanotropic effects: Unlike full α‑MSH, KPV does not affect melanocyte activity or skin pigmentation.
Lifestyle Factors
Complementary strategies for optimizing inflammatory balance.
- Anti‑inflammatory diet: Emphasize whole foods, omega‑3 fatty acids, polyphenols, and minimize processed foods and refined sugars.
- Stress management: Chronic stress elevates inflammatory markers; incorporate stress‑reduction practices (meditation, yoga, adequate sleep).
- Physical activity: Regular moderate exercise supports healthy inflammatory balance; avoid overtraining which can increase inflammation.
- Sleep optimization: Prioritize 7–9 hours of quality sleep nightly to support immune regulation and inflammatory homeostasis.
- Gut health: Support microbiome diversity through probiotic‑rich foods and adequate fiber intake, particularly relevant for inflammatory bowel conditions.
Injection Technique
General subcutaneous guidance from clinical best‑practice resources.
- Clean the vial stopper and injection site with alcohol swabs; allow to dry completely (10–15 seconds).
- Pinch a 1–2 inch skinfold; insert the needle at 45–90° angle into subcutaneous tissue.
- Do not aspirate for subcutaneous injections; inject slowly and steadily over 3–5 seconds.
- Withdraw the needle smoothly and apply gentle pressure with a clean alcohol swab (do not rub the site).
- Rotate sites systematically using a pattern (e.g., alternating between right/left abdomen, right/left thigh) to avoid lipohypertrophy and maintain consistent absorption.
- Preferred sites: abdomen (at least 2 inches from navel), anterior/lateral thigh, or outer upper arm (if administering to self, abdomen and thigh are easiest).
Important Note
This content is intended for therapeutic educational purposes only and does not constitute medical advice, diagnosis, or treatment. KPV is a research peptide not approved by regulatory agencies for human therapeutic use. Consult qualified healthcare professionals before beginning any peptide protocol. This information is provided for educational and research reference purposes only.
Supplies needed
Plan covers the full 8-week protocol at the lowest listed starting dose: 0.25 mg per dose, 5 days on / 2 days off (40 administrations in total), using 10 mg vials. After mixing with 1 mL, the concentration is 10 mg/mL and each dose requires 0.03 mL total.
KPV vials (10 mg each)
Vials are rounded up only after calculating the whole protocol: ceil(10 ÷ 10) = 1. Usable peptide remaining in an opened vial carries forward to the next dose.
- Full protocol (8 weeks)
- 1 vial (10 mg needed ÷ 10 mg)
Insulin syringes (U-100, 1 mL)
One fresh syringe per administration.
- Full protocol (8 weeks)
- 40 syringes
Bacteriostatic water (10 mL bottles)
Use 1 mL per vial for reconstitution (1 × 1 mL = 1 mL).
- Full protocol (8 weeks)
- 1 × 10 mL bottle
Alcohol swabs
One for the vial stopper per draw + one for each injection site (5 days on / 2 days off). Recommend 1 × 100-count box.
- Full protocol (8 weeks)
- 80 swabs
| Supply | Full protocol (8 weeks) |
|---|---|
| KPV vials (10 mg each)Vials are rounded up only after calculating the whole protocol: ceil(10 ÷ 10) = 1. Usable peptide remaining in an opened vial carries forward to the next dose. | 1 vial (10 mg needed ÷ 10 mg) |
| Insulin syringes (U-100, 1 mL)One fresh syringe per administration. | 40 syringes |
| Bacteriostatic water (10 mL bottles)Use 1 mL per vial for reconstitution (1 × 1 mL = 1 mL). | 1 × 10 mL bottle |
| Alcohol swabsOne for the vial stopper per draw + one for each injection site (5 days on / 2 days off). Recommend 1 × 100-count box. | 80 swabs |
KPV dosage FAQs
How do you reconstitute a 10 mg Vial vial of KPV?
Add bacteriostatic water slowly down the inside wall of the 10 mg Vial KPV vial, swirl gently until clear, and use the reconstitution calculator to convert your chosen water volume into syringe units.
What is a typical KPV dose?
Recommended dosage: 250mcg – 1mg daily. Figures are research reference values only.
How often is KPV administered in research protocols?
Injection frequency: Daily — 1–2 times daily — 5 days on, 2 days off (dose Mon–Fri, rest Sat–Sun).
What concentration does reconstituted KPV end up at?
Concentration: 10 mg/mL (1 unit = 0.1mg). On any insulin syringe 1 unit = 0.01 mL, so unit counts convert directly across brands.
What does the KPV kpv dosing guide (10mg / 1ml bac water) look like?
2.5 units — 250mcg; 5 units — 500mcg; 7.5 units — 750mcg; 10 units — 1mg. The full table above lists every step with matching syringe units.
What are the mixing steps for KPV?
Draw 1mL of bacteriostatic water into a sterile syringe. Inject the water slowly down the inside wall of the 10MG KPV vial. Swirl gently until fully dissolved — do not shake.
How should reconstituted KPV be stored?
Storage: Store reconstituted vial refrigerated at 2–8 °C, protected from light. Do not freeze..
How many insulin syringe units equal a KPV dose?
Units depend on the water volume you used. Divide your target dose by the vial concentration to get millilitres, then multiply by 100 — 1 unit on a U-100 insulin syringe is 0.01 mL. The Spartan Peptides reconstitution calculator does this conversion for you.
Is KPV approved for human use?
No. KPV is sold and referenced strictly as a research chemical. Nothing on this page is medical advice and the material is not for human consumption.
Educational and research information only. Not medical advice, not for human consumption. Values are reference figures — always verify your own math with the reconstitution calculator.
On any insulin syringe, 1 unit = 0.01 mL, so unit counts above hold across brands.

