Ipamorelin dosage chart
10 mg Vial
Ipamorelin is dosed at 100 mcg–250 mcg daily via subcutaneous injection in educational protocols. A 10 mg vial reconstituted with bacteriostatic water yields about 3.33 mg/mL. This information is for research and educational use only.
- Reconstitute
- Add 3.0 mL bacteriostatic water → ~3.33 mg/mL concentration.
- Typical daily range
- 100–300 mcg once daily (gradual titration recommended).
- Easy measuring
- At 3.33 mg/mL, 1 unit = 0.01 mL ≈ 33 mcg on a U-100 insulin syringe.
- Storage
- Lyophilized: 2–8 °C (35.6–46.4 °F) or freeze at −20 °C (−4 °F); after reconstitution, refrigerate at 2–8 °C (35.6–46.4 °F) and use within ~4 weeks.
Dosing schedule
| Week | Daily Dose (mcg) | Units (per injection) (mL) |
|---|---|---|
| Weeks 1–2 | 100 mcg | 3 units (0.03 mL) |
| Weeks 3–4 | 150 mcg | 5 units (0.05 mL) |
| Weeks 5–8 | 200 mcg | 6 units (0.06 mL) |
| Weeks 9–12 | 250 mcg | 8 units (0.08 mL) |
Reconstitution steps
- 1Draw 3.0 mL bacteriostatic water with a sterile syringe.
- 2Inject slowly down the vial wall; avoid foaming.
- 3Gently swirl/roll until dissolved (do not shake vigorously).
- 4Label and refrigerate at 2–8 °C (35.6–46.4 °F), protected from light.
Important Notes
Practical considerations for consistency and safety.
- Use new sterile insulin syringes for each injection; dispose in a sharps container.
- Rotate injection sites (abdomen, thighs, upper arms) to reduce local irritation.
- Inject slowly; wait a few seconds before withdrawing the needle.
- Document daily dose and site rotation to maintain consistency.
- Ipamorelin has a short half-life (~1.5–2.5 hours); consistent daily timing maximizes effects.
How This Works
Ipamorelin binds to the growth hormone secretagogue receptor (GHSR-1a) and stimulates the pituitary gland to release endogenous growth hormone in a pulsatile manner. Unlike earlier growth hormone releasing peptides, ipamorelin is highly selective and does not significantly stimulate ACTH, cortisol, or prolactin release at effective doses. After subcutaneous injection, GH levels peak within approximately 40 minutes and return to baseline by 2–3 hours. This short-acting pulsatile effect makes it suitable for once-daily administration to support physiological GH patterns. Animal studies have shown that even chronic daily exposure did not significantly desensitize GH release mechanisms, though cycling is recommended as a precautionary measure. Ipamorelin has also demonstrated pro-motility effects in the gastrointestinal tract via GHSR-1a receptors, with preclinical and clinical studies showing it can accelerate gastric emptying.
Potential Benefits & Side Effects
Observations from preclinical and clinical literature.
- Supports increases in lean body mass and improvements in recovery through GH-mediated anabolic processes.
- Enhances fat metabolism and supports favorable body composition changes over time.
- High selectivity for GH release with minimal impact on other hormones (ACTH, cortisol, prolactin).
- May support improved gastric motility and digestive function.
- Generally well tolerated with a low incidence of side effects at typical doses.
- Occasional mild injection-site reactions (redness, swelling) may occur; very rare reports of water retention or increased hunger.
Lifestyle Factors
Complementary strategies for best outcomes.
- Pair with a balanced, protein-adequate diet to support muscle synthesis and recovery.
- Combine resistance training and cardiovascular exercise to maximize anabolic and metabolic benefits.
- Prioritize 7–9 hours of quality sleep nightly, as GH naturally peaks during deep sleep phases.
- Manage stress levels, as chronic stress and elevated cortisol can blunt GH response.
- Inject on an empty stomach (avoid food 2–3 hours before and 30–60 minutes after) to optimize GH release.
Injection Technique
General subcutaneous guidance from clinical best-practice resources.
- Clean your hands and work on a clean surface.
- Swab the vial’s rubber stopper and injection site with alcohol; allow to dry.
- Draw the calculated dose into the insulin syringe, eliminating air bubbles.
- Suitable SC injection areas include the abdomen (2 inches from navel), outer thighs, upper outer arms, or flank/hip area.
- Pinch a fold of skin between thumb and forefinger; insert the needle at 45–90° into subcutaneous tissue.
- Do not aspirate for subcutaneous injections; inject slowly and steadily.
- After injection, release the pinched skin and withdraw the needle at the same angle.
- Apply gentle pressure with a clean cotton or alcohol pad; do not rub vigorously.
- Rotate sites systematically with each dose to prevent irritation or tissue damage.
- Immediately dispose of the used syringe in a proper sharps container.
important-note
This content is intended for therapeutic educational purposes only and does not constitute medical advice, diagnosis, or treatment.
Ipamorelin dosage FAQs
How much bacteriostatic water do you use to reconstitute Ipamorelin?
Add 3.0 mL bacteriostatic water → ~3.33 mg/mL concentration. for a 10 mg Vial vial. Add the water slowly against the inside wall of the vial and swirl — never shake — until the powder fully dissolves.
What does the Ipamorelin dosing schedule look like?
Weeks 1–2 — 100 mcg — 3 units (0.03 mL); Weeks 3–4 — 150 mcg — 5 units (0.05 mL); Weeks 5–8 — 200 mcg — 6 units (0.06 mL); Weeks 9–12 — 250 mcg — 8 units (0.08 mL). The full table above lists every step with matching syringe units.
What are the mixing steps for Ipamorelin?
Draw 3.0 mL bacteriostatic water with a sterile syringe. Inject slowly down the vial wall; avoid foaming. Gently swirl/roll until dissolved (do not shake vigorously).
How should reconstituted Ipamorelin be stored?
Storage: Lyophilized: 2–8 °C (35.6–46.4 °F) or freeze at −20 °C (−4 °F); after reconstitution, refrigerate at 2–8 °C (35.6–46.4 °F) and use within ~4 weeks..
How many insulin syringe units equal a Ipamorelin dose?
Units depend on the water volume you used. Divide your target dose by the vial concentration to get millilitres, then multiply by 100 — 1 unit on a U-100 insulin syringe is 0.01 mL. The Spartan Peptides reconstitution calculator does this conversion for you.
Is Ipamorelin approved for human use?
No. Ipamorelin is sold and referenced strictly as a research chemical. Nothing on this page is medical advice and the material is not for human consumption.
Educational and research information only. Not medical advice, not for human consumption. Values are reference figures — always verify your own math with the reconstitution calculator.
On any insulin syringe, 1 unit = 0.01 mL, so unit counts above hold across brands.