GHRP-2 dosage chart
5 mg Vial
GHRP-2 is dosed at 100 mcg–200 mcg daily via subcutaneous injection in educational protocols. A 5 mg vial reconstituted with bacteriostatic water yields about 1.67 mg/mL. This information is for research and educational use only.
- Reconstitute
- Add 3.0 mL bacteriostatic water → ~1.67 mg/mL concentration.
- Typical daily range
- 100–300 mcg once daily subcutaneously.
- Easy measuring
- At 1.67 mg/mL, 1 unit = 0.01 mL ≈ 16.7 mcg on a U-100 insulin syringe.
- Storage
- Lyophilized: freeze at −20 °C (−4 °F); after reconstitution, refrigerate at 2–8 °C (35.6–46.4 °F).
Dosing schedule
| Week | Daily Dose (mcg) | Units (per injection) (mL) |
|---|---|---|
| Weeks 1–2 | 100 mcg | 6 units (0.06 mL) |
| Weeks 3–4 | 150 mcg | 9 units (0.09 mL) |
| Weeks 5–8 | 200 mcg | 12 units (0.12 mL) |
| Weeks 9–12 | 200 mcg | 12 units (0.12 mL) |
| Weeks 13–16 | 200 mcg | 12 units (0.12 mL) |
Reconstitution steps
- 1Draw 3.0 mL bacteriostatic water with a sterile syringe.
- 2Inject slowly down the vial wall; avoid foaming.
- 3Gently swirl or roll until completely dissolved (do not shake).
- 4Label and refrigerate at 2–8 °C (35.6–46.4 °F), protected from light.
Important Notes
Practical considerations for consistency and safety.
- Use new sterile insulin syringes for each injection; dispose in a sharps container.
- Rotate injection sites (abdomen, thighs, upper arms) to reduce local irritation and prevent lipodystrophy.
- Very frequent dosing (e.g., every 2 hours) can cause progressive attenuation due to acute tachyphylaxis; once-daily administration avoids this issue.
- Multiple daily injections (2–3×) have been explored but require strict adherence and may offer limited added benefit.
- Document daily dose and site rotation to maintain consistency.
How This Works
GHRP-2 is a synthetic growth hormone secretagogue that binds to and activates ghrelin (GH secretagogue) receptors. This activation triggers potent, pulsatile release of growth hormone from the pituitary gland in a dose-dependent manner. Clinical studies in GH-deficient children demonstrated meaningful GH increases even at low doses (0.3–3.0 mcg/kg), with escalating doses over several months showing sustained efficacy. In healthy adults, doses of 100 mcg SC daily produce acute GH stimulation, while routine protocols typically maintain 100–300 mcg/day to balance efficacy with receptor sensitivity. The peptide has been well tolerated in clinical trials with no significant adverse effects or toxicity reported at these dosage ranges.
Potential Benefits & Side Effects
Observations from clinical and preclinical literature.
- Stimulates robust pulsatile GH release that may support favorable body composition changes and metabolic effects.
- In combination therapies (e.g., with GHRH analogs), can significantly increase IGF-1 levels when administered with perfect compliance.
- Generally well tolerated with placebo-like safety profile; transient side effects may include mild hunger sensation or flushing.
- Long-term therapy (8–24 months in GH-deficient subjects) has maintained positive effects on growth velocity with careful monitoring.
- Occasional mild injection-site reactions (redness, irritation) may occur with subcutaneous administration.
Lifestyle Factors
Complementary strategies for optimal outcomes.
- Maintain adequate protein intake and balanced nutrition to support the anabolic effects of elevated GH.
- Combine with resistance training to maximize body composition benefits.
- Prioritize sleep quality, as GH pulses naturally occur during deep sleep; evening administration may complement this rhythm.
- Manage stress effectively to support consistent adherence and recovery.
- Stay well hydrated to support metabolic processes.
Injection Technique
General subcutaneous guidance from clinical best-practice resources.
- Clean the vial rubber stopper and skin with alcohol swabs; allow to dry completely.
- Use a fine insulin syringe (typically 29–31 gauge, 0.5-inch needle).
- Pinch an inch of skin fat (abdomen, thigh, or outer upper arm); insert needle at 45° to 90° into subcutaneous tissue. (Use 90° angle if ample fatty tissue; 45° for leaner individuals to avoid intramuscular injection.)
- Do not aspirate for subcutaneous injections—aspiration is unnecessary and can cause needless tissue trauma.
- Inject slowly and steadily; wait a few seconds before withdrawing needle at same angle.
- Apply gentle pressure with swab if needed; do not massage or rub injection site.
- Rotate sites systematically to prevent irritation and lipodystrophy—space injections at least 1 inch apart.
important-note
This content is intended for therapeutic educational purposes only and does not constitute medical advice, diagnosis, or treatment.
GHRP-2 dosage FAQs
How much bacteriostatic water do you use to reconstitute GHRP-2?
Add 3.0 mL bacteriostatic water → ~1.67 mg/mL concentration. for a 5 mg Vial vial. Add the water slowly against the inside wall of the vial and swirl — never shake — until the powder fully dissolves.
What does the GHRP-2 dosing schedule look like?
Weeks 1–2 — 100 mcg — 6 units (0.06 mL); Weeks 3–4 — 150 mcg — 9 units (0.09 mL); Weeks 5–8 — 200 mcg — 12 units (0.12 mL); Weeks 9–12 — 200 mcg — 12 units (0.12 mL). The full table above lists every step with matching syringe units.
What are the mixing steps for GHRP-2?
Draw 3.0 mL bacteriostatic water with a sterile syringe. Inject slowly down the vial wall; avoid foaming. Gently swirl or roll until completely dissolved (do not shake).
How should reconstituted GHRP-2 be stored?
Storage: Lyophilized: freeze at −20 °C (−4 °F); after reconstitution, refrigerate at 2–8 °C (35.6–46.4 °F)..
How many insulin syringe units equal a GHRP-2 dose?
Units depend on the water volume you used. Divide your target dose by the vial concentration to get millilitres, then multiply by 100 — 1 unit on a U-100 insulin syringe is 0.01 mL. The Spartan Peptides reconstitution calculator does this conversion for you.
Is GHRP-2 approved for human use?
No. GHRP-2 is sold and referenced strictly as a research chemical. Nothing on this page is medical advice and the material is not for human consumption.
Educational and research information only. Not medical advice, not for human consumption. Values are reference figures — always verify your own math with the reconstitution calculator.
On any insulin syringe, 1 unit = 0.01 mL, so unit counts above hold across brands.

